The “BTU” is a propeller type unit heater that combines the latest tubular heat exchanger and inshot burner technology with the quality and reliability you have come to know with Beacon/Morris. Standard Features: 20 gauge tubular heat exchangers 9 sizes ranging from 100 to 400 MBH Inshot type burner Direct spark ignition system 20 gauge jacket panels with baked enamel finish Power vented Easy access control panel Certified for category I and III venting Terminal strip low voltage wiring 82%+ thermal efficiency 10 year warranty Factory fire tested

The model “BMEB” high efficiency unit heater achieves annual fuel savings of up to 25% over conventional natural vented unit heaters. The “BMEB” features a factory installed power venter and sealed flue collector that controls combustion and excess air during on cycles. Standard Features: 10 sizes ranging from 100 to 400 MBH ETL certified for 80% efficiencies Aluminized steel heat exchanger- 20 gauge Optional 409 and 321 stainless steel heat exchangers Single stage gas valve (STD) Optional two stage and modulating gas valves Standard spark ignition Available in Natural or LP gas Easy burner access with individual removable burners Optional duct flange connection in lieu of discharge louvers 1O year […]

The “BMED” and “BMES” are power vented indoor duct furnaces. Model “BMED” offers bottom burner access and is typically ceiling suspended. The model “BMES” offers side access and is typically mounted on a non-combustible floor. Both models offer high efficiencies that achieve annual fuel savings of up to 25% over conventional natural vented unit heaters. Also featured is the factory installed power venter and sealed flue collector that controls combustion and excess air during on cycles. Standard Features: 10 sizes ranging from 100-400 MBH ETL certified for 80% efficiencies Aluminized steel heat exchanger 20 gauge Optional 409 and 321 stainless steel heat exchangers Single stage gas valve (STD) Optional two […]

Approved for residential use, thousands of homeowners have installed Beacon/Morris BRT units in their garages. By design, our BRT units are compact and fit nicely in the corner of a garage. The unique hanging mechanism allows the installer to mount the unit close to the ceiling, further keeping the heater out of the way of the homeowner. Most commonly, BRT garage heaters are used with natural gas. If natural gas isn’t available, units are available for use with propane as well. Beacon/Morris unit heaters not only keep your garage environment comfortable, but also may help prolong the life of your car’s engine by eliminating cold start-ups in the dead of […]